Use; Power On/Off - Mectron combi touch Manual De Uso Y Mantenimiento

5

USE

5.1 Power On/Off
Switching the appliance on
The switch is positioned at the rear of the
device, on the left.
Flick the switch into the "I" position, taking
care not to press the pedal.
All the warning lights on the device will turn
on and off again. The keyboard stays off for a
few moments until an acoustic signal indicates
the end of the diagnostic cycle. At the end of
the diagnostic cycle, the system loads the
preset configuration and is ready for use.
Preset configuration:
• ULTRASOUND part:
• mode: "endo";
• power: "1";
• light: "Off";
• irrigation: tank - medium flow.
• POLISHING part:
• "Prophy" function.
NOTE: The settings of the scaler part and
polisher part can both be modified only with
the handpieces stowed in their housings. If
either of the two handpieces are extracted,
only the settings relative to the active
function can be modified.
Switching the appliance off
The switch is positioned at the rear of the
device, on the left.
Flick the switch into the "O" position, taking
care not to press the pedal.
ON
CAUTION: Position the device in a way
that the power plug is easily accessible at all
times; this is considered a means of isolation.
USE
23