Initial Operation; Installation Site Requirements - Spring SOUS VIDE STICK PROFESSIONAL Manual Del Usuario

- Pull the power plug after each use and:
- when the device is not under your direct supervision
- in case of faults during operation
- each time you clean the device
Always pull on the plug and not on the cord.
- After use, always place the appliance on heat-resistant, non-flammable and waterproof surfaces only.
Danger!
Only immerse the device in water up to the MAX marking, but never beyond. Do not immerse the
housing, the power cord or plug in water or any other liquids and never spray water directly onto the
appliance. Do not clean it in the dishwasher.
Danger!
Never use the appliance if you discover damage, if water has penetrated the housing or if the appliance
has been dropped. If you notice damage during use, unplug it from the power supply immediately.
Danger!
Check the power cord for damage before every use. If the power cord is damaged, it must be replaced
immediately. This may only be arranged by the manufacturer, his customer service or a similarly
qualified and authorized specialist.
5

Initial operation

Danger!
Observe the Installation site requirements described in chapter 5.1.
Caution!
Do not leave children unattended in the vicinity of the hot device.
Risk of burns or injury!
High temperatures are generated during operation of the appliance.
5.1

Installation site requirements

- Fix the appliance at sufficiently high, stable and heat-resistant cookware only. We recommend the use of an
appropriately large cooking pot. Position it in a way that it does not have to be moved during the entire cooking
procedure. Place the pot on a stable, sufficiently heat-resistant surface out of reach of children. Keep a safe
distance to hot cooktops, gas flames or other sources of heat.
- Make sure that the appliance is fixed vertically at the pot rim and has a firm hold.
- During the operation hot steam will form. Make sure that there is enough space next to and above the
appliance/pot.
- Ensure that the power cord does not have any contact to hot surfaces at the device or other hot surfaces such
as cooktops or hot liquids. Make sure it does not pass over sharp edges and is not kinked or bent.
- Also ensure that the power cord used does not hang down from the table or counter so that no one can trip
over it and cause the appliance to be pulled down.