Setting The Cutting Depth; Sliding Cut; Work-Piece Supports - Femi Job Line TR 1030-DB Manual De Instrucciones

Ocultar thumbs Ver también para Job Line TR 1030-DB:
Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

SETTING THE CUTTING DEPTH

The vertical depth of the cut can be adjusted, allowing
the mitre saw to cut a groove.
When setting the cutting depth make sure that the disk
may not touch the base, in the lower position; the disk
could damage the base.
To set the depth:
1. Lift the head in the higher position.
2. Loosen the bolt (C) Fig.12.
3. Adjust the knob (B) to the desired cutting depth.
4. Tighten the bolt (C).
Note : In case the cutting depth (A) is set too short, the
disk wont cut through the work-piece. Always make a
test-cut after setting the cut depth

SLIDING CUT

1. Loosen the knob (A) Fig.13 to release the sliding
device.
2. Pull or push the operating handle to slide the head
along the guides
3. Tighten the knob (A) to block the sliding device
Note : Warning ! before transporting the mitre saw,
make sure that the sliding device is blocked

WORK-PIECE SUPPORTS

Use the lateral extensions available, to support long
pieces during the cut. Position the extensions as
described above, see CUT-END GUIDE EXTENSIONS
EN
43
Fig.12
Fig.13

Publicidad

Tabla de contenido
loading

Tabla de contenido