Cut-End Guide Extensions; Assembly And Regulations; Fixing The Mitre Saw Onto A Bench; Check And Setting Of The Angles - Femi Job Line TR 1030-DB Manual De Instrucciones

CUT-END GUIDE EXTENSIONS

The cut-end guide can be extended on both sides in
case of wide work-pieces. To do this:
Loosen the exagonal screw (B) Fig.8 with an
exagonal wrench.
Loosen the knob (C).
Slide the extension (A) on the desidred position and
tight the screw (B), then the the knob (C).
WARNING!
Before changing the settings of the mitre saw, make sure it is unplugged from any power
source.
The following setting procedures have to be followed, to grant a safe, precise and efficient
operation.
Once all the settings are made, make sure that all the wrenches and tools are away from the
machine and that screws, bolts and protections are correctly fixed and active
Do not use the mitre saw before having carefully followed these procedures
While making these settings, make sure that all the protections are properly working and are in
good conditions
Broken or damaged parts have to be replaced by a qualified mechanic, before using the
machine.

FIXING THE MITRE SAW ONTO A BENCH

Before its use, the mitre saw has to be fixed onto a bench
Four holes are placed on the corners of the base, to screw it onto a bench or a working surface.
If you want to use lateral extensions, assemble them before fixing the machine on a bench
If the machine is to be frequently moved, fix it on a plywood base (20mm thick or more) so that it will be
possible to fix it on a base with clamps
WARNING : Make sure that the plywood base is flat, otherwise this could affect the cutting
precision.
Check and verify the following settings for a correct cutting precision

CHECK AND SETTING OF THE ANGLES

The different positions for angle cutting have been set at the origin by the factory
Nevertheless, in order to grant a precise work, verify that all angles are correct before cutting
EN

ASSEMBLY AND REGULATIONS

40
Fig.8