Tecnogas FastPipe Manual De Instalacion Y Declaracion De Garantia página 22

Using the crimping tool
It is recommended to carefully carry out the operations described and in the order in which they are
described. It is also necessary to refer to the Crimping Tool User Manual for all information relating to its
EN
ordinary and extraordinary maintenance, as well as for any other procedure not covered in this Manual.
Installing the crimping die in the crimping tool:
Open the head of the crimping tool (picture 13);
1.
Insert one of the two parts of the die on the ram;
2.
Insert the other half on the mobile part of the crimping tool head, ensuring that the centring pins
3.
are facing each other in an opposite position (picture 14).
Crimping the fitting:
Open the head of the crimping tool (picture 13);
1.
Insert the fitting (picture 15);
2.
Slowly operate the loading lever (picture
3.
position. For the battery crimping tool , intermittently press the load button (picture
proceed with the exact positioning of the bushing on the die;
It is recommended to align the end of the bushing opposite the nut with the outer edge
of the die
Complete an initial crimping by operating the lever or the load button
4.
hydraulic
Once the initial crimping has been carried out, release the pressure with the release lever (picture
5.
- B) located under the head of the machine. If you have a battery crimping tool, press the
1
discharge button (picture
bushing on the clamps, respecting the corners;
Complete the second crimping by operating the load lever until the automatic release of the relief
6.
valve (audible due to its characteristic noise). If you have a battery crimping tool, press the load
button until the machine stops automatically;
Release the pressure once more as specified in step 5;
7.
Reopen the crimping tool and remove the crimped fitting.
8.
Installing FastPipe
It is recommended to carefully carry out the operations described and in the order in which they are
described.
Laying the pipe
Open the
1.
FastPipe
Start positioning
2.
with curvature radii lower than those allowed and listed below:
Fasten
3.
FastPipe
If
4. FastPipe
or spinodes may occur. The Product can be restored to its original form simply using the hands;
If
5. FastPipe
centimetres, so as to bend the circuit at a different point along the Product;
22
(picture 16)
.
ram;
- B). Then turn the tube or the crimping tool 90°, repositioning the
2
System
®
roll, by cutting the film and containment bands;
®
in the wall or in the plastic duct, taking care not to bend the Product
FastPipe
®
1/4"
65 mm
to the wall or plastic duct using suitable fastening methods;
®
is improperly bent or if the curvature radius is lower than those allowed, restrictions
®
is not restored to its original shape, it may be advisable to move the pipe a few
®
FastPipe installation manual and warranty statement
®
- A), to align the bushing on the die in the correct
1
3/8" 1/2"
95 mm 130 mm 170 mm
2
up to half way on the
5/8"
- A), to