Storage Conditions - Tecnogas FastPipe Manual De Instalacion Y Declaracion De Garantia

Screwdriver bits for 1/4" and 3/8" (or 1/2" - picture
•
SuperGrip gloves (picture
•
Spray oil (picture
• 10
Anti-UV protective tape (picture
•
Required installation material not included
In addition to
FastPipe Starter
®
crimping dies for each diameter of the system;
• FastPipe
®
Complete connection kit for each diameter of the system;
•
Electric screwdriver (not included);
•
Cutter (not included - only for the installation of curved supports).
•

Storage conditions

must not be exposed to adverse weather conditions or stored in damp environments.
FastPipe
®
So as not to damage the Product, it is also necessary to properly seal the ends of the same using the
caps provided for each coil (or similar - picture 12).
Incorrect storage of FastPipe
can cause malfunctioning in the connected Units.
Dewatering
If has been stored without complying with the provisions of the previous paragraph, it
FastPipe
®
must be dewatered.
To do this, seal one end and purge the system using a vacuum pump (not included).
The dewatering operation can only be considered completed when the internal pressure of
is permanently below 500 mTorr.
FastPipe
®
The internal pressure level is measured via an electronic vacuum gauge which is not included. The
pressure is stably below 500 mTorr if, when the vacuum pump is switched off, the value indicated
by the vacuum gauge does not exceed this threshold.
FastPipe
);
9
);
).
11
Kit, the following equipment is required to complete the installation:
may result in the buildup of humidity inside the tubing, which
®
installation manual and warranty statement
®
) fittings;
8
EN
21