ERSA i-CON 2V MK2 Manual Breve página 34

Changing the heating element
Fig. 4: Soldering
tip proper mount-
ing
8. Changing the heating element
Risk of burns! Only change the heating element when both the soldering tip and
the heating element are cold!
Before changing the heating element, switch off the soldering station and allow
the soldering tip and the heating element to cool down!
Fig. 5: Replace the heating element
Ersa GmbH
a) To check the soldering tip for tight seating:
Maintain the correct distance of the knurled sleeve [2] to the soldering iron [3]
as per the illustration
Make sure that the bayonet mount of the knurled sleeve is completely locked.
The display panels [1] do not touch the knurled sleeve [2].
CAUTION
a) Remove the soldering tip.
b) Pull the heating element out by hand.
ü Slide in the spare heating element.
a) Align the groove of the heating element [1] with the marking in the soldering
iron [2].
b) Align the heating element exactly parallel to the soldering iron.
c) Gently push the heating element in carefully and slowly until it stops. If the
heating element cannot slide in easily, do not press with greater force, but re-
position it!
d) Re-install the soldering tip.
3BA00270 | Rev. 1 17