Printing On Chocolate Bars & Objects - Procusini mini Manual

5. Printing on chocolate bars & objects
On object offers you the possibility to set a new start height,
e.g. to print directly on chocolate bars.
Proceed as in chapter 5.2 and 5.3 and set a 3D Choco Refill resp. own
chocolate at the beginning.
Select "On object" under Menu and follow the instructions on the display.
NOTE
!
• Do not place the object (e.g. chocolate bar)
until the display prompts you to do so.
• Place the object centrally under the print nozzle.
• Move the print nozzle down until it touches the surface of the object
without damaging it!
5.1 After printing on object
If the print is finished or has been stopped, you can set the height again.
If the next print is to be made on the silicone mat again, follow the instructions in
the next section "Returning to normal printing".
Remove the printed object from the print table before continuing!
5.2 Return to normal printing
If you want to return to normal printing, go to the main screen via the back
button and select "Print".
+ +
+
22