Cleaning; Washing The Underside Of The Mower Deck - Toro TimeCutter Max Manual Del Operador

Replacing the Grass Deflector (continued)
5. Remove the damaged or worn grass deflector.
6. Install the new grass deflector.
7. Slide the straight end of the rod through the rear grass deflector pivot.
8. Place the spring on the rod, with end wires down, and between the grass deflector
brackets.
9. Slide the rod through the second grass-deflector pivot.
10. Insert the rod at the front of the grass deflector into the bracket on the deck.
11. Secure the rear end of the rod into the mower with the nut.
The grass deflector must be spring-loaded in the down position. Lift the deflector up
to test that it snaps into the full-down position.

Cleaning

Washing the Underside of the Mower Deck

You can wash the machine with a mild detergent and water. Do not pressure wash the
machine. Avoid excessive use of water, especially near the control panel, under the
seat, around the engine, hydraulic pumps, and motors.
Wash the underside of the mower deck after each use to prevent grass buildup for improved
mulch action and clipping dispersal.
1. Park the machine on a level surface, disengage the blade-control switch (PTO), and
move the motion-control levers outward to the P
2. Shut off the engine, remove the key, and wait for all moving parts to stop before leaving
the operating position.
3465-589A
IMPORTANT
IMPORTANT
position.
ARK
Page 5–32 Maintenance: Cleaning