Cleaning The Battery - Toro TimeCutter Max Manual Del Operador

Battery Service (continued)
Do not overcharge the battery; otherwise, you could damage it.
3. When the battery is fully charged, unplug the charger from the electrical outlet (if
applicable), then disconnect the charger leads from the battery posts.

Cleaning the Battery

Note:
Keep the terminals and the entire battery case clean, because a dirty battery
discharges slowly.
1. Park the machine on a level surface, disengage the blade-control switch, and move the
motion-control levers outward to the P
2. Shut off the engine and wait for all moving parts to stop before leaving the operating
position.
3. Remove the battery from the machine.
4. Wash the entire case with a solution of baking soda and water.
5. Rinse the battery with clear water.
6. Coat the battery posts and cable connectors with Grafo 112X (skin-over) grease or
petroleum jelly to prevent corrosion.
7. Install the battery.
3465-589A
IMPORTANT
G003792S
ARK
Page 5–16
Positive battery post
Negative battery post
Red (+) charger lead
Black (-) charger lead
position.
Maintenance: Electrical System Maintenance