cecotec POWER TITANIUM 900 PROGO Manual De Instrucciones página 31

5. TROUBLESHOOTING
Problem
Blender does not switch
on
Blender makes noise
The blender does not mix
properly
Liquid leakage during use
Possible cause
Loose plug
Defective PULSE button
Damaged motor
Worn bearings in the
motor
Motor overload
Defective gasket in the
blades assembly
Cracks in the jug or blades
assembly
Incorrect assembly of the
blades assembly
Possible solution
Make sure that the plug is proper-
ly connected and try another plug.
Check if the button is working
properly. If necessary, contact the
official Cecotec Technical Support
Service.
If the motor is damaged, it is ad-
visable to contact the official Ce-
cotec Technical Support Service.
If the noises are coming from the
motor, it may be necessary to
replace the bearings. Contact the
official Cecotec Technical Support
Service.
Avoid overloading the blender
with heavy ingredients. Reduce
the amount and try again.
Check that the gasket is in good
condition Make sure it is posi-
tioned correctly.
Inspect the jug and blades as-
sembly for cracks. If you find any,
replace the affected part.
Be sure to assemble all parts
correctly before use. Refer to the
instruction manual if necessary.
POWER TITANIUM 900 PROGO
ENGLISH
31