Technical Data; Noise/Vibration Information - Proxxon WAS/A Manual

1 pc. Operating instructions
1 pc. Safety guidelines
1 pc. Grip
1 pc. Grinding mop cylinder K 120
1 pc. Grinding mop cylinder K 240
1 pc. Satin-fi nishing cylinder
Article 29827:
1 pc. WAS/A cylinder sander
1 pc. Safety guidelines
1 pc. Grip
1 pc. Grinding mop cylinder K 120
1 pc. Grinding mop cylinder K 240
1 pc. Satin-fi nishing cylinder

4 Technical data

Motor:
Voltage: 1
Device:
Length:
Weight:
Spindle velocity:
Maximum tool
diameter:
Noise development:
General measuring
uncertainty:
Grip vibration:
Charger:
Mains voltage:
50/60Hz
Output voltage:
Charging current:
Battery:
Rechargeable lithium-ion battery
Nominal/charging voltage: 10.8V/12.6V
Energy/Capacity:

5 Noise/vibration information

The information on vibration and noise emissi-
on has been determined in compliance with the
- 18 -
0,8 V
approx. 320 mm
approx. 950 gr.
1100-2600 rpm
50 mm
< 70 dB(A)
K=3dB
≤ 2.5 m/s 2
100-240V~,
12.6 V
1 A
28.19Wh/2.61Ah
3 INR 19/66
prescribed standardised and normative measu-
ring methods and can be used to compare elec-
trical devices and tools with each other.
These values also allow a preliminary evalua-
tion of the loads caused by vibration and noise
emissions.
Warning!
Depending on the operating conditions while
operating the device, the actually occurring
emissions could differ from the values speci-
fi ed above!
Please bear in mind that the vibration and noise
emission can deviate from the values given in
these instructions, depending on the conditions
of use of the tool. Poorly maintained tools, in-
appropriate working methods, different work
pieces, too high a feed or unsuitable work pi-
eces or materials or unsuitable bits and cutters
can signifi cantly increase the vibration load and
noise emission across the entire work period.
To more accurately estimate the actual vibra-
tion and noise load, also take the times into
consideration where the device is switched off,
or is running but is not actually in use. This can
clearly reduce the vibration and noise load ac-
ross the entire work period.
Warning!
• Ensure regular and proper maintenance of
your tool
• Stop operation of the tool immediately if ex-
cessive vibration occurs!
• Unsuitable bits and cutters can cause exces-
sive vibration and noises. Only use suitable
bits and cutters!
• Take breaks if necessary when working with
the device!