Fitting The Side Walls; Anchoring The Tent - Partyspace Flexxum SET1515PVCL Manual De Instrucciones

14 FLEXXUM - MANUAL

FITTING THE SIDE WALLS

1. Attach the flaps on one side of the f irst side wall f rom top to bottom to a leg. The opening
in the canvas goes around the pin of the leg.
2. Aff ix the Velcro at the top of the side wall to the inside of the roof. Begin on the side where
the side wall has already been attached to the leg.
3. Attach the flaps on the other side of the side wall f rom top to bottom.
4. Aff ix the flaps on one side of the second side wall to the rear of the side wall already f itted.
5. Aff ix the Velcro at the top of the side wall to the inside of the roof. Begin on the side where
the side wall has already been attached to the previous one.
6. Repeat step 3. Attach all the side walls in the same way.
1.
3.
2.
EN EN

ANCHORING THE TENT

At each corner of the roof canvas is a ring, to which you can attach a tension strap.
Pull this tight.
You can secure the bottom edges of the side walls using tent pegs in the loops provided for
this purpose. There are also holes in the base plates of the legs for this purpose. You can also
place weights on the base plates.
15 FLEXXUM - MANUAL