Connecting The Cables; Tilt The Screen; Adjust The Height Of The Screen - Rehan i-See HD Manual De Instrucciones

4.2

Connecting the cables

Connect the power and video cables from the base to the monitor. Connect the data
cable from the base to the control interface.
Monitor
EN
4.3

Tilt the screen

Loosen the bolts at both rear sides of the screen; this loosens up the screen so you can
move it in your preferred position. Tighten the bolts to secure the screen at that position.
4.4

Adjust the height of the screen

With the i-See HD it is possible to adjust the height of the screen. Simply grab the lever
at the right side of the TFT screen, pull it towards you and, while holding your left hand
at the lower left corner of the screen, slide the screen up or down. Release the lever to
secure the screen at that position.
16
Control interface
i-See HD