Mida Tool Eye Electrical Arm Installation Procedure - marposs MIDA TOOL EYE Manual De Instalacion Y Uso

5.2 Mida Tool Eye Electrical Arm installation procedure

ATTENTION
The operations described in this chapter must be carried out by specialised personnel.
Interrupt the electrical power supply by setting the mains switch to 0 and locking it in
position with a padlock, as shown in the adjacent figure.
To install the MIDA Tool Eye measurement Arm it is necessary to mount the mechanical parts on the tool
machine and the E32A-SSR in the electrical cabinet, connect the sensor to the E32A-SSR, and connect the
latter to the PLC/CNC.
Section 5. INSTALLATION 71