Placement; Leveling - Tripp-Lite SmartRack SRCOOL3KTP25U Manual Del Propietário

Enclosure Installation

Placement

Use the casters to move the enclosure for a short distance over a level,
smooth, stable surface by pushing it from the front or rear (not the
side panels). Do not attempt to roll the enclosure over long distances.
WARNING: Do not push or pull the enclosure at the side panels or
pull the enclosure toward you.

Leveling

WARNING: Level the enclosure before attempting to install equipment. The casters are not designed to provide
long-term support for the enclosure. Use the levelers to provide long-term support. Install the enclosure in a
structurally sound area with a level floor that is able to bear the weight of the enclosure, all equipment that will be
installed in the enclosure and any other enclosures and/or equipment that will be installed nearby.
1
After the enclosure has been moved to the installation location, use
a carpenter's level to check the slope of the floor. If the floor slopes
more than 1%, choose an alternate installation site.
2
Use an 18 mm open-end wrench to lower each leveler
reaches the floor. (There are 4 levelers, 2 at the front and 2 at the
rear.) Make sure each leveler contacts the floor solidly.
Note: Lower a leveler by turning it clockwise; raise a leveler by turning it
counter-clockwise.
1
A
until it
2
7
FLOOR
A