Connection With The Mains; Operation; Sound-Control Operation; Display And Function Buttons - EuroLite TS-2 DMX-Scanner Manual Del Usuario

Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the TS-2 starts running.
With the POWER-switch, you can switch the device on and off.
During the Reset, the motors are trimmed and the device is ready for use within approximately 20 seconds.

Sound-control operation

You can do without a controller as the TS-2 features a built-in microphone, which provides automatic sound
control.

Display and Function Buttons

Press the Function Button and select from the functions F1 – F6.
International
L
N
24/52
Ω
resistor
51785765_V_1_2.DOC