Gas Supply; Electrical Supply - GE Profile PGP9830 Manual Del Propietario E Instrucciones De Instalación

INSTALLATION PREPARATION (Cont.)

7. GAS SUPPLY

These cooktops are designed to operate on natural
• These cooktops are shipped from the factory set
for natural gas. If you decide to use this cooktop
made by a service technician or other qualified
person.
• The pressure regulator must be connected in
series with the manifold of the cooktop and must
remain in series with the supply line regardless of
type of gas being used.
• When checking the regulator, the inlet pressure
output setting. If the regulator is set for 4" of water
column pressure, the inlet pressure must be at
column pressure, the inlet pressure must be at
codes permit, the gas supply line into the cooktop
connector, three to five feet long.
• If you are not sure about the inlet pressure,
contact local gas supplier.
NOTE:
• Make gas connection through rear wall, or on
cabinet floor at rear, as illustrated.
22
Installation Instructions

8. ELECTRICAL SUPPLY

2"
min
29 "
2
3"
min
C L
Gas pipe
location
The built-in gas downdraft cooktop features pilotless
electric ignition for energy savings and reliability.
fuse or circuit breaker, is required.
• A properly grounded 3-prong receptacle should be
located within reach of cooktop's four foot power
cord.
IMPORTANT:
The power cord of this appliance is equipped with
a standard three-prong grounding wall receptacle
to minimize the possibility of electric shock hazard
from this appliance. The customer should have the
wall receptacle and circuit checked by a qualified
electrician to make sure the receptacle is properly
grounded and has correct polarity.
Where a standard two-prong wall receptacle is
encountered, it is the personal responsibility and
obligation of the customer to have it replaced with a
properly grounded three-prong wall receptacle.
Electrical outlet
" above
cabinet floor
(mount on
side or back
cabinet wall
2" min. from
49-2001159 Rev. 0