Serial Data Output Via Printer Z 910 - Xylem SI Analytics Lab 745 Manual De Instrucciones

54
7.3

Serial data output via Printer Z 910

The current measured values and the calibration information can be cyclically output via a printer.
Use only interface cable (Interface HMG Drucker) to transfer data from the meter to the printer.
This cable is not included in the delivery and must be purchased separately ( chapter 12
Accessories).
To use this function, press (CONF). This will take you to the menu item "Configuration" and on to the
submenus item "protocol" choose "Printer" and setup the "cycle time".
To print the calibration information press (LOG) in the "INFOMRATION" menu (2x (INFO).
Printer configuration Z 910: