Tabla de contenido
Publicidad
FM10_DE_RU_80S_977091-02_final.qxp_Innenseiten_FM10.qxd 25.02.19 11:00 Seite 1
l
ATTENTION!
We hereby explicitly state that we have no li-
ability whatsoever under the German Prod-
uct Liability Law for any damage caused as a
result of unauthorised repairs or by the use of
replacement parts that were not original
Wetrok
spare parts, and where the repair
work was not done by our after-sales service
section or an authorised technician. This also
applies to accessory parts.
DANGER!
Danger of life from fire and/or explosion!
Danger to life if the device is not used as in-
tended! For this reason, observe the following
safety instructions:
l
When handling hazardous substances al-
ways wear appropriate protective clothing,
including protective gloves and breathing
protection.Avoid any sources of ignition in
the vicinity and ensure that the work
place is well ventilated.
l
Inflammable media may not be applied
with this device.
WARNING!
Contact with cleaning fluids poses a
health risk!
Inhaling, swallowing or skin contact with
cleaning fluids may impair your health to
some extent. If symptoms occur, or in case
of doubt, consult a doctor. Consult a doctor
if you develop symptoms or are unsure.
For this reason, observe the following safety
instructions:
- Observe the safety instructions on the
cleaning substance labels. Safety goggles,
protective gloves or other protective
measures are advised when using certain
foam cleaners.
- Always request a safety data sheet accor-
ding to 1907/2006/EC from the spraying
agent manufacturer. This states the re-
commended protective equipment and
measures for each agent.
Equipment
l
Safety / pressure relief valve (A)
l
Valve body complete (B)
l
Felt washer(C)
l
Flat spray nozzle (D)
l
Connecting nipple(E)
l
Pump pipe (F)
l
Push button(G)
Intended Use
l
The industrial device
foaming liquid cleaning agents as far as
those agents do not affect the materials
used.
l
The device may only be used for applying
media which are suitable for foaming.
Foam formation is influenced by:
1.the concentration of the medium in the
solution.
2.the water hardness.
3.the disposition of the medium to foam.
4.the number of felt washers (C) used.
11
GB
N
SF1
is designed for
Publicidad
Tabla de contenido
