LORCH MicorStick 200 ControlPro Manual De Instrucciones página 23

Before operation
12 Before operation
6
4
Fig. 2: Transportation belt
Transportation belt
6
Plastic slides
27
12.1 Fasten transportation belt
 Thread the transportation belt into the welding ma-
chine and plastic slides. See sequence of the number
in the picture.
12.2 Connecting the ground cable
When you select the workplace, pay attention to the
proper connection of ground cable and ground clamp.
The ground clamp shall be attached to the workpiece or
the welding table in a way that the clamp is fixed onto
a blank, conductive area. It shall be located right next
to the weld point to avoid an uncontrolled backflow of
the welding current through machine components, ball
bear-ings, electric boards and circuits.
09.16
27
5
1
909.2779.9-00
6
80 mm
2
L (R)
1
L (S)
2
L (T)
3
N(MP)
PE
1
1
Fig. 3: Ground cable
Do not place the ground clamp on the welding machine
or gas cylinder, otherwise welding current is conducted
via the protective conductors and will destroy them.
Never put the ground clamp loose onto the workpiece.
Connect the clamp properly to the welding table or the
workpiece.
3
2
- 23 -
1