Other Components - ECOVACS ROBOTICS DEEBOT 6 Manual De Instrucciones

4.3 Other Components

Clean the Universal Wheel by removing any
hair tangled around the Universal Wheel.
Wipe the Dust Sensors with the brush or the
felt side of the Multi-Function Cleaning Tool
to maintain their effectiveness.
* Remove DEEBOT 6's battery if the robot will not be used for a long time. In case of battery leakage,
please remove the battery and wipe the battery slot clean while wearing protective gloves.
*
If battery is fully discharged or not used for a long time, its capacity may decrease and need to be
reactivated.
*
To reactivate the battery: Place the robot on the Charging Dock by hand, remove after charging
for 3 minutes; repeat 3 times, then charge normally for 3-5 hours.
*
DEEBOT 6 uses a long life Ni-MH battery, and does not require frequent replacement. To replace
the battery, contact Customer Service or follow the below instructions:
a. Unscrew the Battery Cover Screws, remove Battery Cover.
b. Remove the battery and disconnect the fasteners.
c. Connect the corresponding positive and negative fasteners on the new battery. Insert
the new battery, reassemble the Battery Cover and screw in the Battery Cover Screws.
All manuals and user guides at all-guides.com
4. Maintenance
Wipe the Anti-Drop Sensors with the brush
or the felt side of the Multi-Function Cleaning
Tool to maintain their effectiveness.
Wipe the Charging Contacts and Charging
Dock Pins clean with a dry cloth.
15
EN