Malfunctions - Auping Kiruna Sami Manual De Instrucciones

All manuals and user guides at all-guides.com

5. Malfunctions

While an electrical fault may be a nuisance, it is never dangerous. All motors and
controls are fitted with all necessary safety devices and have double insulation.
The table at the next pages gives possible solutions to malfunctions.
If you have any doubts contact your dealer.
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Undesirable noises (bed
squeaks and creaks)
Sparks fly when the
box spring control
system is being
plugged into the
transformer
Motor runs for a while
then stops
Strange occurrences.
Motor does not adjust,
or only partially, etc.
Wrong motor engages
Nothing works
_059PM_4556 - BW.pdf - pag.19
Cause
Caused by moving parts
touching each other.
The box spring is not
leveled because the floor
is not absolutely flat.
The reason for this may
be a missing part, or
parts that have not been
tightened properly or
have become loose when
the bed was moved.
The bed is not positioned
away from the wall.
There are unwanted
objects in the bed that
should not be there
(spoons, forks, pens,
etc.).
The plug is already in
the wall socket before
the box spring control
system is connected.
Faulty Hall sensor in
motor.
Processor malfunction.
Wrongly installed.
The plug is not in the
socket.
LET OP !!! Lage resolutie!
Search Solution
Apply Teflon spray.
Do not use oil.
Make sure the floor is
absolutely leveled.
Tighten parts.
Position the bed away
from the wall.
Remove those objects.
First connect the box
spring control system,
then put the plug into
the socket.
Set bed in horizontal
mode by alternately
adjusting up and down a
little at a time. Replace
motor.
Reset. Unplug the bed,
wait a short while then
plug back in.
Install according to
fitting chart.
Put the plug into the
socket.
February 9, 2010
GB19