Slackline Industries Primitive Kit Manual Del Usuario página 7

TENSIONING ANCHOR
Take the free end of webbing from the line lock and pull it towards the tension anchor and up
through oval carabiner C on the tension anchor and back towards the line lock on the slackline and
pass it through carabiner B from above.
TENSIONING ANCHOR
Feed the slackline webbing through each carabiner a second time so it goes under the webbing
from the first pass. Ensuring it goes under the webbing will allow the slackline to stay at desired
tension.
TENSIONING ANCHOR
Pull the tail of the slackline to desired tension. It will stay in place if you have ensured to go
underneath the webbing in step above.
NOTE: Slackline Industries' 1-inch webbing is low-stretch and can be pulled tight by a single person
on lengths up to 50 feet. DO NOT over-tighten.
TENSIONING ANCHOR
3.6 BREAK DOWN:
To detension the slackline, pull the tail of the line up and out from under the outside pass of the
webbing on the carabiners to release.
FOR MORE INFORMATION VISIT:
www.slacklineindustries.com
C
C
SLACKLINE INDUSTRIES PRIMITIVE KIT MANUAL-ENGLISH
B
B