INTIRION Micro fridge 2.5MF4RE Manual Del Propietário página 5

OPERATING INSTRUCTIONS
DOOR REVERSAL INSTRUCTIONS
If the appliance is placed on its back or side for any
length of time during this process, it must be allowed
to remain upright for 6 hours before plugging it in
to avoid damage to the internal components.
1. Remove the hinge cap by twisting it off. Remove
the screws and the upper hinge from the upper
right side of the cabinet. Remove the hole covers
from the upper left side of the cabinet and
install them in the screw holes on the upper right
side of the cabinet. Remove the door from the
cabinet.
2. Remove the screws and the lower hinge from
the lower right side of the cabinet. Remove the
solid foot from the lower left side of the cabinet.
Install the solid foot on the lower right side of the
cabinet. Install the lower hinge on the lower left
side of the cabinet.
3. Reinstall the door on the cabinet. Install the
upper hinge on the upper left side of the cabinet.
Before tightening the screws on the upper hinge,
ensure that the top of the door is level with the
top of the cabinet and that the rubber gasket is
making a good seal with the cabinet. Install the
hinge cap.
HINGE CLIP INSTALLATION INSTRUCTIONS
1. Remove the cord retaining clip from the
accessory bag.
2. Align the hooks on the cord retaining clip with
the slots on the hinge cover.
3. Push downward to clip the cord retaining clip
over the top of the hinge cover.
Note: Do not route high voltage electrical cords
under the hinge clip. Only use the clip to cover low
voltage electrical cords.
1
2
3
4