Publicidad
Idiomas disponibles
Idiomas disponibles
T310 Product Map
T310 Operation
1. On: press & hold the
seconds to indicate the T310 is ON). Headset is now in STANDBY mode.
NOTE: previously paired devices will automatically connect to the T310 headphones when turned on
2. Press
and
percentage (English voice prompt)
3. Off: press & hold the
NOTE: T310 will power off automatically after 10 minutes if not used in standby mode
T310 Wireless Pairing
1. Pairing: Make sure T310 is OFF. Press & hold
(blue/red flashing LED indicates the device is ready for pairing)
2. Enable Bluetooth function on your electronic device. Search Spector T310 & pair the devices (blue LED
will flash once every 10 seconds when paired)
NOTE: To DISCONNECT from Bluetooth pairing, press & hold
see the LED flash blue & red again.
T310 Operation in Wireless Mode
1. Answer/End calls & Play/Pause function: quickly press the
2. Rejecting a call: press & hold the
3. Redialing last outgoing call: in standby mode, double click
4. To answer an incoming call while already on a call, double click
original call)
5. To switch call from T310 to connected phone, press & hold
button for 4 seconds until the LED flashes BLUE (LED will flash blue every 5
buttons simultaneously while in standby mode to hear the remaining battery power
for 4 seconds until the LED light flashes RED
button
button for 7 seconds until LED light flashes blue & red
&
buttons until you hear an audio prompt and
button
(double click
during a call
again to return to
Publicidad
