Electric Oven; Sostitution Of The Lamp; Sostitution Of The Electrical Components; Replacing The Heating Element - LIBRETTO EM E6/11-D Instalación, Uso, Mantenimiento

AFTER REPLACING A GAS SYSTEM COMPONENT, CHECK FOR GAS LEAKS AT
CONNECTION POINTS.
DISCONNECT THE APPLIANCE ELECTRIC SUPPLY, IF PRESENT, BEFORE CARRYING OUT
ANY OPERATION.
AFTER REPLACING AN ELECTRICAL SYSTEM COMPONENT, CHECK IT IS CORRECTLY
WIRED.

ELECTRIC OVEN

SOSTITUTION OF THE LAMP

- Open the oven door.
- Remove the protection
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in reverse order.

SOSTITUTION OF THE ELECTRICAL COMPONENTS

- Remove right panel
- Remove the control panel
- Remove and replace the component.
- Reassemble all parts. For assembly, proceed in reverse order.

REPLACING THE HEATING ELEMENT

- Remove right panel
- Remove the interior panel
- Remove the water distributor
- Undo the screw securing the element to the oven and pull the element out by approx. 10 cm.
- Reassemble all parts. For assembly, proceed in reverse order.

13. CLEANING THE INTERIOR

Check the condition of the inside of the appliance.
Remove any built-up dirt.
Check and clean the fumes exhaust system.

14. MAIN COMPONENTS

PROGRAMMABLE ELECTRIC OVEN

- Safety thermostat
- Heating element
- Lamp
- engine
- Electronic board
- Inverter
- Touch screen
26