Ptz Control (1Ch Mode) - Avtech IC-AVH516 Manual De Instrucciones

4.4 PTZ Control (1CH mode)

Note: This function is available only for "SUPERVISOR" and "POWER USER". To know more details,
please refer to "4.3 User Level Creation" at page 13.
In the full view
In the split view, click the channel you want to switch to the full screen mode, and click
control panel.
The panel might be different according to different models.
/ /
/
/
/
/
Click on the channel status bar to display the panel as follows:
Camera Menu
Enter
Up / Down / Left / Right
/
Iris + / Iris -
Zoom in / out max
Zoom in / out
Focus near / far
Auto mode
Preset point
Auto tracking
PTZ speed
configuration
DPTZ
Up / Down / Left / Right
/ / /
Digital zoom in / out
/
Focus near / far
/
Preset point
Click to enter the camera main menu.
For details about each camera menu, please refer to its own user
manual.
Click to confirm your selection / enter the menu.
Click to move your selection up / down / left / right, or change settings.
This two buttons are designed for the PTZ camera which uses
Pelco-D to control. To know the actions after clicking Iris + and Iris -,
please refer to the camera's user manual.
Click to zoom in on the image to the largest / zoom out on the image
to its original size.
Click to zoom in / out the image.
Click to adjust the focus of the image.
Click to activate the auto function.
Before using it, you need to assign a specific function that will be
enabled when " " is clicked. For details, please refer to the user
manual of the PTZ camera.
Click to enter the PTZ preset point you want to see.
Click to start auto tracking when your speed dome camera supports
this function.
Adjust the speed bar to change the pan, tilt and auto pan speed.
Digitally pan, tilt and zoom in or out your camera.
Click to move your selection up / down / left / right, or
change settings.
Click to zoom in / out the camera image digitally.
Click to adjust the focus of the image.
Click to display the preset point panel for preset point
viewing or setting. For details, please refer to the section
below.
15
FREQUENTLY-USED FUNCTIONS
to show the PTZ