Emc Tables - I-Tech I-PRESS 4 Manual De Empleo

EMC tables

Guidance and MANUFACTURER'S declaration – ELECTROMAGNETIC EMISSIONS
– FOR ALL THE EQUIPMENT AND THE SYSTEMS
I-PRESSS 4 is intended for use in the electromagnetic environment specified below. The
customer or the user of the I-PRESS 4 should assure that it is used in such an
environment.
Emission test
RF emissions
Cispr 11
RF emissions
Cispr 11
Harmonic emissions
IEC 61000-3-2
Voltage fluctuations/
flicker emissions
IEC 61000-3-3
Guidance and MANUFACTURER'S declaration – ELECTROMAGNETIC IMMUNITY
– FOR ALL THE EQUIPMENT AND THE SYSTEMS
I-PRESS 4 is intended for use in the electromagnetic environment specified below. The
customer or the user of I-PRESS 4 should assure that is used in such environment.
Immunity test
Electrostatic
discharge (ESD)
EN 61000-4-2
IACER SRL
Compliance
Group 1
Class B
Class A
Complies
Complies
Test level EN
60601-1-2
± 6kV contact
± 8kV air
Pagína 23
Electromagnetic environment –
guidance
I-PRESS 4 uses RF energy only for its
internal function. Therefore, its RF
emissions are very low and are not
likely to cause any interference in
nearby electronic equipment
I-PRESS 4 is suitable for use in all
establishments,
establishments
connected to the public low-voltage
power supply
buildings used for domestic purposes.
The I-PRESS 4 is suitable for use in all
establishments, other than domestic
establishments
connected to the public low voltage
power supply network that supplies
buildings used for domestic purposes
Compliance level
± 6kV contact
± 8kV air
including domestic
and those directly
network that supplies
and those directly
Electromagnetic
environment –
guidance
Floors should be
wood, concrete or
ceramic tile. If floor
are covered with
synthetic material,
the relative humidity
should be at least
30%
MNPG222-00 24/03/16