Infrared Remote Control; Setting The Comfortslides - Auping AVS 455 Manual De Instrucciones

4.3 Infrared remote control*

On delivery, corresponding handset and
control units are set to the same
channel. In order to prevent that the IR
controls of two beds in the same room
will interfere
operation, each should be switched
to its own IR channel. Red slider
switches can be found in the battery
compartment of the handset and on the
control unit. Both switches should be
set either to the left or right (see fig. 3).
left
right
If both beds are adjusted simul -
taneously using the infrared remote
control or, at the same time, another
remotely controlled is used, the infrared
frequencies may interfere with one
another. In such cases, please operate
the beds and/or appliances separately.
* If applicable.
_03PII_4473 BW.pdf - pag.27
All manuals and user guides at all-guides.com
with one another's
fig. 3
LET OP !!! Lage resolutie!

4.4 Setting the Comfortslides

The mesh base can be adapted to the
shape of your body. The slides are
incorporated in the mesh base at both
shoulder and hip level.
• Remove the mattress from the mesh
base.
• The illustrations of the various
positions of the Comfortslides
examples only. You can of course set
the slides to the position you
consider the most comfortable.
• Lift the slides slightly, then slide
them to the desired positions.
• Replace the mattress on the mesh
base.
For technical reasons AVS mesh bases
wider than 120 cm cannot be equipped
with Comfortslides ® .
®
®
are
GB27
November 12, 2009