RECARO C 6000 RENAULT Manual De Montaje página 38

Warning:
The screws in the kit are micro-encapsulated and should never to be used more than once.
The micro-encapsulation will become ineffective if they are repeatedly used and the permanent
securing of the screw connection can no longer be guaranteed.
14. Screw the two front screws (2) into the seat adapter using the stipulated torque. (Torx adapter T30)
Torque: M8 screws: 25 Nm ± 2 Nm
15. Now move the RECARO seat as far forward as possible.
16. Screw the four rear screws (3, 4) from the installation kit into the adapter (finger-tight only).
17. Tightly screw the four screws (3, 4) at the rear using the stipulated torque.
Torque: M8 screws: 25 Nm ± 2 Nm
Danger:
If the torque is not set correctly, the screws will work loose whilst you are driving.
In this case, the safety concept can no longer be ensured and the vehicle may no longer be used.
The screws must be tightened using the stipulated torque.
O
1
18. Refit the air duct (1) (if present).
RECARO Automotive Seating
2
R0226
1 Air duct
2 Safety latches
(T30 Torx adapter).
Page 16