HP AMP Manual Del Usuario

HP AMP
Need help?
www.hp.com/support/amp100
Power : Press to turn the printer on or off. Press and hold to light up all the buttons.
1
When the power light is blinking, the printer is receiving and processing a job.
Cancel : When it lights up, press to stop current operation. When the printer is not active,
2
press to print a status report.
Wireless
3
capability is on, but the printer is not yet connected to a wireless network. If the blue light stays
on, the printer is connected to a wireless network.
Control panel display: Indicates wireless status
4
status , paper-related warnings
Information
5
blinking, press to get help for a warning or error.
6
Resume
7 Phone : Press to answer an incoming call, and then press again to end the call.
8,10 Volume
9 Play/Pause
Bluetooth
Press until the light flashes to enter Bluetooth paring mode. On your mobile device, select
11,12
HP AMP from a list of Bluetooth devices to pair.
Press and hold for eight seconds to reset Bluetooth.
Audio is stopped during printing to ensure the best print quality. It automatically resumes again
shortly after printing is completed.
To pair additional devices, make sure no other Bluetooth devices are connected to the speaker.
Eight paired Bluetooth devices can be stored in the printer memory. Two Bluetooth devices stored
in the printer memory can be connected at the same time.
*T8X39-90073*
*T8X39-90073*
T8X39-90073
: Press to turn wireless capabilities on or off. If the light is blinking, the wireless
: Press to print the printer information page. If the button is amber and
: When it lights up, press to resume printing.
: Press to increase or decrease volume.
: Press to play or pause the audio stream, and to mute or unmute a phone call.
: Press to turn Bluetooth on or off.
EN
DA
and signal strength
or other errors, and ink levels
DE FR IT ES
FI ET LV LT
The information contained herein is subject to change without notice.
, Wi-Fi Direct
.
PT NL SV NO
© Copyright 2017 HP Development Company, L.P.
Printed in [English]