Interruptions - Silca Tri-Code Manual De Uso

Operating manual - English
Release the lever (N) turn the depth regulating (O) dial by hand and check that it is in position 5 (you
should hear a click).
5.9.5

INTERRUPTIONS

• WHAT TO DO IF THE DISPLAY SHOWS:
Indicates that the machine has been turned on again after an interruption.
Press START or ENTER to continue; the display will show:
Raise the safety shield,
loosen the lever/handle (N).
Turn cutter chuck dial to the left until it reaches position 16 (you will feel position it clicks).
Turn the clamp (F) knob and remove the key.
Turn the cutter chuck dial to the right until it reaches its original position.
Tighten the lever/handle (N).
Lower the safety shield and press START.
The display will show first:
then return to the initial menu.
• WHAT TO DO IF THE DISPLAY SHOWS:
Indicates that the cutting cycle has been interrupted (with STOP).
Press the START button to turn on the cutter again. The upper carriage will make a straight run towards
the operator in order to leave the cutting operation. The key will be a reject.
Press the ENTER button; the display will show:
Raise the safety shield,
loosen the lever/handle (N).
Turn the cutter chuck dial to the left until it reaches position 16 (you will feel position it clicks).
Turn the clamp (F) knob and remove the key.
Turn the cutter chuck dial to the right until it reaches its original position.
Tighten the lever/handle (N).
Lower the safety shield and press START.
The display will show first:
66
A T T E N T I O N
T h e m a c h i n e w a s
t u r n e d - o f f d u r i n g
a w o r k c y c l e !
I t i s r e q u e s t e d t o
z e r o o u t t h e a x e s
P r e s s [ S T A R T ]
t o p r o c e e d .
P o s i t i o n i n g
i n p r o g r e s s !
A T T E N T I O N
C y c l e i n t e r r u p t e d !
K e y w i l l b e d a m a g e d
[ E N T E R ] [ S TA R T ]
S e e o p e r a t i n g m a n u a l
t o a v o i d a m i s c u t
k e y .
[ S T A R T ]
P o s i t i o n i n g
i n p r o g r e s s !
Copyright Silca 2006
TRI-CODE H.S.