Digital Projection iVision 20 XB Guia Del Usuario página 62

english
deutsch francais español
factory reset
Factory reset erases all memorised source and system
settings, and sets all back to default values .
service
Service enters the service menu . This is available to
authorised service personnel only . Entering the service menu
without proper knowledge may permanentely damage the
projector .
remote control ID
The projector can be set up to have a unique ID, so that
it only responds to remote controls transmitting the same
ID . Up to 99 units can be handled without interfering with
eachother, using the same remote . By default, the projector
is set to respond to any one remote control, thus is set to
"broadcast" . To change, and set a unique ID, select, and
change the value with the left / right arrow keys .
To set the remote control to broadcast to a specific ID, press
the asterisk key ("*"), and enter a number that corresponds
with the projector you wish to control using the numeric
keypad . When pressing the asterisk key towards a projector,
it will respond with its unique ID, and prompt the user to
enter a matching one .
DPMS
Enable or disable the DPMS (Display Power Management
Signalling) . When enabled, the projector will automatically
switch to standby mode after a specified time if there is no
valid source present at its inputs . When a valid source is
reconnected, the projector will start up again .
DPMS timeout
DPMS can be set from 1 – 180 minutes . Default is 30
minutes .
backlight timeout
Set the amount of time before the backlight for the on-board
keypad fades out after use . Default is 30 seconds .
menu timeout
Set the amount of time before the menu automatically goes
away if not used . Default is 30 seconds .
splash
Select the splash screen to be displayed if no valid source is
connected . Options include black, grey, and white .
baudrate
Set the baudrate at which the projector communicates over
RS232 . Options include 4800, 9600, and 19200 bps . See
separate documentation for details on RS232 and LAN
communications .
62