Attaching The Bump Head - Trueshopping BC2602D Manual De Montaje Del Propietario

• Finger tighten the locknut anti clockwise and
then tighten fully with the socket tool.
• Finally, remove the Allen key.
• The blade in now ready for use.

Attaching the Bump head

This instruction shows you how to attach the
strimmer bump head to your multi tool.
•
Remove the nut and large bell washer from
the head assembly (as shown in the brush
blade instruction)
•
Rotate the large washer until the hole in the
side lines up with the hole on the head
assembly. Then insert the 4mm Allen key
through the two holes to prevent the
assembly from moving.
•
Pick up the bump head and place the
threaded connection on the bump head
onto the threaded connection point in the
centre of the head assembly.
•
Screw the bump head onto the central fixing
by rotating it anti-clockwise, it is important
12