Appendix; A Overview Of Operating And Display Functions; Operating And Display Functions - Vaillant VPV I Serie Instrucciones De Funcionamiento

Appendix

A Overview of operating and display functions
Note
The functions and operating modes listed are not available for all system configurations.
A.1

Operating and display functions

Setting level
Basic display →
Output power ²
Current day yield ¹
PV voltage ¹
PV current ¹
Grid voltage ²
Grid current ¹
Grid freqency ¹
Internal temp. ¹
Derating ¹
Day max. power occurred: ¹ ³
Abs. max. power occurred: ¹ ³
Day max. yield occurred: ¹ ³
Operating hours ¹
Total yield ¹
CO² saving ¹
Main menu →
Yield
Remuneration ¹
Self consumption ¹
Autarky level ¹
Settings
¹ This menu item is not always displayed. Whether or not it is present depends on the unit type, the settings on the inverter, and the
firmware version.
² This menu item is always displayed. It is not possible to switch it off.
³ Can be reset to 0 via Main menu → Settings → Clear event log.
0020273427_02 VPV I Operating instructions
Values
Unit Increment, select, explanation
Min. Max.
Current value W Output power of the inverter
Current value kWh Daily yield since 00:00
Current value V Voltage supplied by the PV generator
Current value A Current supplied by the PV generator
Current value V Voltage at the inverter connection
Current value A Current that is fed into the network
Current value Hz Frequency of the power grid
Current value °C Inside temperature of the inverter
–
Current Possible displays:
condition
–
–
–
–
–
–
–
–
–
Current value W Highest power for the current day
Current value W Highest fed-in power
Current value kWh Max. daily yield that is reached
Total value h Operating hours at the power grid (including
night-time hours)
Total value kWh Yield since start-up
Total value kg CO
2
The value is calculated using the reduction factor
508 g/kWh.
–
–
Displays the list with yield periods.
– –
Displays the list with yield periods (Remunera-
tion).
– – –
– – –
– –
Displays the Settings sub-menu.
not active
Reason: Overheating
Reason: Frequency
Reason: extern.
Reason: Restart
Reason: Reactive power
Reason: User limit
Reason: Frequency too high
Reason: Frequency too low
reduction since start-up
Appendix
Factory set-
ting
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
–
9