Menu Settings - Fonexion ideus ITDECT200 Manual De Usuario

UP
∧
DOWN
∨
ITDECT200
R Flash/Delete
P Redial/Pause
Star/Lock
Ring on/off
MU Mute
Page
Intercom
2 INSTALLATION
Plug the main power lead into the bottom of the base unit.
Plug the main adapter into mains socket with the switch on the socket set to off.
Switch on main power at the socket.
Fit the batteries in the handset
Powering up the handset, press and hold key
* The power adapter is the disconnect device for this equipment, the socket-outlet shall
be near the equipment and easily accessible.
* Batteries must be charged through the base at first time at least 12 hours non-stop in
order to increase their lifetime and obtain an optimal performance.
* All passwords are set by default "0000".
3

MENU SETTINGS

During idle state, press the OK key to enter the menu setting, press UP or DOWN key to
select the above items and then press OK key to enter. Press
or press to back to the previous menu. Details of each item are shown in next parts.
Note: The system will time out if you leave more than 30 seconds between key presses.
22
EN
Increasing the volume;
Review incoming number, outgoing number and phonebook
number.
Scrolling down through lists and menu options;
Decreasing the volume.
Review incoming number, outgoing number and phonebook
number.
The key is used to delete memory;
Delete the current input by a short pressing during menu edit.
The key will perform PAUSE function if pressed after any digit input
both in talk mode and in standby mode;
Redial the last dialed number.
A Long press (2s) to activate keypad lock;
To set up a conference call.
In addition to its use for text and number entry;
To switch the handset external call ringer on/off by long press.
In talk mode press the key to perform mute function.
Page the handset;
Register the handset to a specified base.
To set up an internal call to another handset;
To transfer an incoming call to another handset;
To set up a conference call with an external line and an internal
handset.
USER GUIDE
to quit the setting state,