What Should I Do If - Wella Professionals contura Manual De Instrucciones

Contura.book Seite 31 Freitag, 6. Januar 2012 1:01 13
Cleaning the charging contacts
If the charging contacts 7 on the appliance or the
charging contacts 3 on the charging unit are dirty,
charging may not be possible or may be interrupt-
ed.
– Clean the contacts using a cloth or wad of cotton
wool soaked in alcohol or spirit.
Care of the NiMH rechargeable battery
To maintain the charging capacity of the rechargea-
ble battery we recommend occasionally running the
battery down until the motor stops.
If the battery is run down (motor stops), be sure to
switch the On/Off switch 4 to 0 and place the appli-
ance in the charging unit.
– Make sure you do not leave the appliance
switched on when putting it aside if the battery
is run down.
– Make sure the appliance is switched off (On/Off
switch to 0) when you place it in the charging
unit.

5 What should I do if ...

... the appliance will not switch on?
– Is the battery low? Plug in the mains adapter
for the charging unit and recharge the Contura.
Make sure the On/Off switch is in the 0 position.
– Is the blade head dry? The blade head needs
oiling. Proceed as described on Page 30.
... the blade head "sticks"?
– The blade head needs oiling. Proceed as
described on Page 30.
... the charging indicator does not light up when
charging?
– Clean the charging contacts.
– The appliance may not be positioned correctly
in the charging unit. Position it correctly.
– Is the charging unit properly connected?
... the charging indicator flashes during charging?
– The appliance is in the charging unit of the pre-
vious model. The appliance will take 16 hours
to charge up. You can recognise the new charg-
ing unit by its darker colour.
31